Installing Options
Installing the 1394 Interface Unit
A
Check the contents of the box for
the following items:
• 1394 Interface Unit
• 1394 interface cable (6 pin x 4
2
pin)
• 1394 interface cable (6 pin x 6
pin)
• Installation Guide
B
Be sure to check the following
points:
• The power switch is turned off.
• The power cord is unplugged
from the wall outlet.
• The interface cable is un-
plugged from the printer.
Note
If the Duplex Unit is not in-
stalled, go to step D.
C
If the Duplex Unit is installed,
push down the lever on right side
(A A A A ) and pull it out until the Du-
plex Unit stops (B B B B ).
Zcex320j.eps
32
D
Use a coin to remove the two
screws.
Note
These screws are used again in
step N.
ZCEX280J.eps
E
Pull out the handle of the control-
ler board.
Zcex371j.eps
F
Pull the handle and slide the con-
troller board out.
Zcex261j.eps
G
Place the controller board on a flat
surface.