Ricoh AP2600N User Manual page 358

Appendix
Message
Print server <print server name> has no print-
er.
Print session full
Printer "printer name" has no queue
pserver start. (NetWare)
Required computer name (<Computer
name>) is duplicated name
Required file server ("file server name") not
found
restarted.
6
sap enable, saptype=<SAP type>, sap-
name=<sap name>
Set context to <NDS context name>
shutdown signal received. network service re-
booting...
smbd start. (NetBEUI)
Snmp over ip is ready.
Snmp over ipx is ready.
snmpd start.
The print server received error "error num-
ber" during attempt to log in to the net-
work.Access to the network was denied.Verify
that the print server name and password are
correct.
94
Description and Solutions
(In print server mode) The printer object is not
assigned to the print server <print server
name>. Using NWAdmin, assign the printer
object, and then restart the printer device.
Cannot accept the print session.
(In print server mode) The print queue is not
assigned to the printer. Using NWAdmin, as-
sign the print queue to the printer, and then re-
start it.
(In print server mode) NetWare service has
started.
The same computer name is detected on the
network. The start job determines the comput-
er name by adding the computer name to the
suffix (0,1....). Configure a new computer
name that is unique.
Cannot find the required file server.
LPD has started.
The SAP function has started. The SAP (SAP
type and SAP name) packet is issued to adver-
tise the service on the SAP table on the Net-
Ware server.
A <NDS context name> has been set.
Rebooting the network service.
An smbd (SMB (Server Message Block) ser-
vice) has started.
Communication over TCP/IP with SNMP is
available.
Communication over IPX with SNMP is avail-
able.
SNMP sevice has started.
Cannot log in to the file server. The print serv-
er is not registered or the password is speci-
fied. Register the print server without
specifying a password.