Ricoh AP2600N User Manual page 52

Configuring the Printer for the Network
K
If you use NetWare, select the
frame type for NetWare.
Select one of items below if neces-
sary.
• Auto (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet II
• EthernetSNAP
3
Note
Usually, use the default setting
("Auto"). When if you first se-
lect "Auto", the frame type de-
tected by the printer is adopted.
If your network can use more
than two frame types, the print-
er may fail to select the correct
frame type if "Auto" is selected.
In this case, select the appropri-
ate frame type.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Frame Type (NW)".
B Press { { { { Enter #} } } } .
The current setting appears on
the panel display.
C Press { { { { U U U U } } } } or { { { { T T T T } } } } to display the
frame type you want to use.
D Press { { { { Enter #} } } } .
40
L
Reset the printer to apply the set-
tings.
A Press { { { { Online} } } } to enter the "Of-
fline" condition.
Zdds022N.eps
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
The Online indicator turns off.
B Press { { { { Job Reset} } } } .
Zdds023N.eps
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
M
Print the configuration page to
check settings you have made.
A Press { { { { Menu} } } } .
B Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"List/Test Print" menu.
C After confirming that "Config.
Page" is on the display, press
{ { { { Enter #} } } } .
D Press { { { { Enter #} } } } .
The configuration page is now
printed. Check the contents of
the configuration page.
E Press { { { { Online} } } } .
"Ready" message appears on
the panel display.
Data In
Data In