Ricoh AP2600N User Manual page 47

Connecting the 1394 interface cable to
the printer
A
Attach the 1394 interface cable to
the jack on the board.
Both jacks are available.
ZDDP290E.eps
B
Connect the other end of the 1394
interface cable to the computer or
the other IEEE 1394 node.
Note
The 1394 Interface Unit could not re-
ceive data from more than one PC at
the same time. In this case, an error
message appears. The printer can
accept data sent from other PCs, af-
ter the first print job has finished.
The bidirectional transmissions
are not supported by the 1394 In-
terface Unit.
When the 1394 Interface Unit is in-
stalled successfully, the printer icon
automatically changes from "Use
Printer Offline" to "Ready", accord-
ing to the 1394 interface cable plug.
After installing the last option that
you want, print a configuration
page to confirm the installation. If
the new device is listed in the col-
umn of configuration options, then
it has been properly installed. For
more information about printing a
configuration page, see "Printing a
Configuration Page" in the Printer
Reference provided as a PDF file
on the CD-ROM labeled "Operat-
ing Instructions".
- 1394 Interface Unit - - -
specification
Interface Connector:
IEEE 1394 (6 pin
Required cable:
1394 interface cable (6 pin x 4 pin, 6
pin x 6 pin)
Important
You cannot plug devices togeth-
er so as to create loops.
Do not use a cable more than 4.5
meters (14.8 feet) long.
Connectable number of device in a
bus
Maximum 63
Allowed cable hops in a bus
Maximum 16
Power supply
Non power supply
Installing Options
2)
35
2