Ricoh AP2600N User Manual page 433

QUICK INSTALLATION GUIDE
Please read the Safety Information in the Setup Guide or Printer Reference before using
this machine. It contains important information related to USER SAFETY and PREVENT-
ING MACHINE PROBLEMS.
UNPACKING THE PRINTER AND
WHERE TO PUT THE PRINTER
CHECKING THE CONTENTS OF
The printer's location should be carefully chosen
because environmental conditions greatly affect its
THE BOX
performance.
Check the contents of the box according to
Warning
the following list. If one or some items are miss-
Confirm that the wall outlet is near the machine
ing, please contact your sales or service rep-
and freely accessible, so that in event of an
resentative. emergency, it can be unplugged easily.
Only connect the machine to the power source
described on this sheet.
Important
Avoid multi-wiring.
The interface cable is not included in the box. Make
Do not damage, break or make any modifica-
sure that the interface cable you use, is appropriate
tions to the power cord. Do not place heavy ob-
for your computer.
jects on it, pull it hard or bend it more than nec-
essary. These actions could cause an electric
shock or fire.
Quick Installation Guide (this sheet)
Setup Guide
Caution
CD-ROM
Keep the machine away from humidity and dust.
A fire or an electric shock might occur.
Power Cord
Place the machine on a strong and level sur-
Printer (including a starter toner cartridge)
face. Otherwise, the machine might fall and
Additional Documentation
cause personal injury.
If you use the machine in a confined space, con-
Remove the plastic bag. Lift the printer and move
firm that there is a continuous flow of air.
it to the place where you want to install it.
Optimum Environmental Conditions
When lifting the printer, use the inset grips on both sides of the printer.
Recommended temperature and humidity
%RH
80
60
40
20
Remove the three pieces of adhesive tape
from the printer as shown in the illustration.
%RH
80
60
40
20
The machine must be level within 5 mm, 0.2" both front to rear
and left to right.
Environments to Avoid
Locations exposed to direct sunlight or strong light
Dusty areas
Areas with corrosive gases
Areas excessively cold, hot, or humid
Locations near an air conditioner or humidifier
Locations near other electronic equipment
Locations where the printer might be subjected to
frequent strong vibration
<G058-8620>
Power Connection
Connect the power cord to a power source with the follow-
ing specifications:
220-240V, 50/60Hz, 4.5A or more
Space Required for Installing the Printer
Leave enough space around the printer. This space is neces-
sary to operate the printer. The recommended (or minimum)
space requirement is as follows:
A: more than 10 cm (4.0")
B: more than 10 cm (4.0")
C: more than 100 cm (40.0")
D: more than 10 cm (4.0")
10 C 80% 27 C 80%
15 C 25 C
32 C
70% 70%
54%
25 C
15 C
30% 30%
10 C 15% 32 C 15%
10 20 30 C
80.6 F 80%
50 F 80%
59 F 77 F
70%
70%
89.6 F
54%
59 F 77 F
30% 30%
89.6 F 15%
50 F 15%
F
50 60 70 80 90
Possible operation range Recommended range
Important
Hold the toner cartridge as shown in the illus-
INSTALLING THE TONER
tration, and shake it side to side, about seven
to eight times.
CARTRIDGE
Warning
Do not incinerate spilled toner or used toner. Toner
dust might ignite when exposed to an open flame.
Disposal can take place at our authorized dealer
or at appropriate collection sites.
If you dispose of the used toner cartridge your-
self, dispose of them according to your local regu-
lations.
Note
Caution
Do not eat or swallow toner. If the toner cartridge is not shaken enough, toner
might not be evenly distributed in the cartridge. In
Keep toner (used or unused) and the toner car-
this case, print quality might be reduced.
tridge out of reach of children.
Our products are engineered to meet the highest
Place the toner cartridge on a flat surface. Pull
standards of quality and functionality. When pur-
out the tape inside the unit horizontally while
chasing expendable supplies, we recommend
holding the cartridge with one hand as shown
using only those provided by an authorized dealer.
in the illustration.
Important
Do not expose the toner cartridge to a light for a
long time. If you do, the toner cartridge will be
damaged and the print quality might be reduced.
Open the front cover by pushing the front cover
release button.
Important
Be sure to remove the tape completely before installing
the toner cartridge. Otherwise, the printer might be
damaged.
Be sure to pull the tape horizontally. Pulling it
upward or downward may cause the toner to scatter.
Remove the fixing material inserted between
Be careful not to make your cloths dirty with toner.
toner cartridge and the printer.
After pulling the tape out of the cartridge, toner scatters
easily. Do not shake the cartridge.
Holding the grips of the toner cartridge, insert
it into the printer until it stops.
While lifting the front side of the toner cartridge,
pull it out of the printer.
Note
Do not hold the toner cartridge upside down or
stand it vertically.
Do not put the toner cartridge on an unstable
or tilted surface.
Push down the toner cartridge to settle it in the
appropriate position.
Close the front cover.
Important
Do not close the front cover with force. If you
cannot close the cover easily, pull out the toner
cartridge from the printer and insert it again.
After that, close the front cover again.