H
Use a coin to remove the two
screws, and then remove the cover.
Note
These screws are used again in
step K.
Zcex410j.eps
I
To uninstall the Network Inter-
face Board, pinch and push the
positioning peg. If the Network
Interface Board is not installed,
go to step J J J J .
Important
When you uninstall the Net-
work Interface Board, be careful
not to damage the controller
board.
Zcex430e.eps
Zcex421e.eps
J
Attach the 1394 Interface Unit to
the Slot until it clicks.
Zddp230e.eps
K
Use the two screws to fasten the
1394 Interface Unit to the control-
ler board.
Zddp250e.eps
L
Set the controller board to the "{ { { { "
position, and then slide it into the
printer slowly until it stops.
ZDDP260E.eps
Installing Options
2
33