Nortel Meridian Meridian 1 Feature Description And Administration page 1186

Page 1186 of 1814
LD 14 – The WTM prompt is provided for EXUT and XCOT cards. This prompt should be set to
YES if firmware timing is to be done for the flash and the card supports this functionality. If the
prompt is set to YES for one unit, it is also set to YES for all other units.
Prompt Response
REQ NEW
CHG
TYPE DID
COT
TN l s c u
c u
XTRK EXUT
XCOT
FWTM (NO) YES
CUST xx
RTMB xxx
yyy
LD 73 – Define the DTI2 flash time range.
Prompt Response
REQ NEW
CHG
TYPE DTI2
FEAT abcd
SICA 2-16
...
FALT (R) abcd
N
P RRC (S) abcd
553-2901-301 Standard 9.00 January 2002
Malicious Call Trace Enhancements
Description
Add new data.
Change existing data.
Direct Inward Dialing Trunk.
Central Office Trunk.
Terminal Number.
For Option 11C.
Enhanced Extended Universal Trunk.
Extended Central Office trunk card.
Firmware timing for the trunk hook flash is available. This
prompt is set to YES if firmware timing for trunk hook flash
is supported by the pack.
Customer number.
Trunk route.
Member number for RCD.
Description
Add new data.
Change existing data.
2.0 Mb Digital Trunk Interface
Digital signaling category.
SICA table number.
Fault (DTI out-of-service).
If Fault is not required.
Register recall signal activated by MCT.