Nortel Meridian Meridian 1 Feature Description And Administration page 1137

LD 17 – Configure Phantom Loops .
Prompt Response
REQ CHG
TYPE CEQU
...
- DTI2 xx
ISDN Semi Permanent Connections for Australia
— Configure Direct Inward Dialing route (non-ISL) in LD 16;
— Configure Meridian Communication Adaptor or Meridian
Communication Unit in LD 11; and
— Define one TN on Phantom DTI2 loop in LD 14
• On the SLAVE SIDE:
— Configure Direct Inward Dialing route (non-ISL) in LD 16;
— Configure Data Interface in LD 11; and
— Define one TN on the Phantom DTI2 loop in LD 14.
It is assumed that the ISL D-channel has been configured (LD 16). The
following settings are recommended: RS-232 for 19.2 kbps and below, HS
(RS-422) for speeds above 19.2 kbps, MCA/MCU configured as 64 kbps and
DTE device configuration.
Note: ISPC uses a new set of commands in LD 96 to monitor the
SLAVE SIDE. These new commands are STAT ISPC lp ch, EST ISPC
lp ch and RLS ISPC lp ch. Additionally, in LD 60, the STAT command
identifies the channel used as ISPC link to a PBX by indicating the ISPC
mnemonic.
Description
Change.
Change Common Equipment Parameters.
2.0 Mb Digital Trunk Interface or DTI loop number.
Precede loop with an "N" to configure this loop as a
phantom loop for trunks.
International ISDN PRI Feature description and administration
Page 1137 of 1814