Upgrade 3.X To 5.X; Re-Calculating Data Storage Parameters; Database Upgrades; Preparing Supervisor Interface To Cc Mis - Nortel CC MIS User Manual

Release 5.2
CC MIS Maintenance Guide

Upgrade 3.x to 5.x

Refer to Chapter 11 for information on upgrading from Release 3.1 (or
later) to 5.x. (You must be running at least Release 3.1 to upgrade to
4.1.)

Re-calculating data storage parameters

After conversion from 3.x to 5.x is complete, you must access the
Configuration menu in maintenance. Then, under the Partition Con-
figuration option, examine and save the data storage parameters. This
is necessary to ensure that the space allocated is correctly calculated
for the new Release 5.x configuration. After the parameters are saved,
you can start the partition. Refer to Chapter 7 for information on data
storage and starting partitions.

Database upgrades

The upgrade script upgrades all three databases to a Release 5.x level.
The upgrade script upgrades the configuration database (such as ter-
minals, printers, and links) and the customer's definitions database
(such as formula definitions, report definitions, and supervisor defini-
tions).

Preparing supervisor interface to CC MIS

After the CC MIS host has Release 5.x installed, the supervisor PCs
can be upgraded using the procedures in this section.
This procedure prepares PCs to display the supervisor interface to
CC MIS. The standard (English) version of Microsoft Windows NT
4.0 or Windows 95 software must have already been installed prior to
performing this procedure.
The term "Windows" used throughout this guide re-
fers to a version of Microsoft Windows and is a
Note:
trademark of the Microsoft Corporation.
Perform the steps in the procedure below to prepare PCs to display the
supervisor interface to CC MIS.
CC MIS
CC MIS
2-11