Figure 8.10 Add Partition And Commands Menus - Nortel CC MIS User Manual

CC MIS
8-14
The Partition Configuration with the Add Partition window and the
commands menu displayed is shown below.

Figure 8.10 Add Partition and Commands menus

The commands in the Add Partition Commands menu are listed
below.
Table 8-6: Add Partition commands menu
Command Description
Cancel Aborts the Add Partition procedure.
Submit Adds the partition to the Partition Configuration with and
exits the Add Partition procedure.
Partitions must be defined using the Partition Configuration screen.
Partition names can be up to 16 characters in length. The initial set-
tings for a new partition are Mode=Setup and State=Stopped. The
partition type (local or NAP) is specified when adding a partition. The
NAP option will not be available to nodes that are not allowed to have
NAPs or if the Maximum limit of NAPs has been reached.
Release 5.2
297-2671-545