Installing Release 5 - Nortel CC MIS User Manual

CC MIS
Automated
Calculations
In Release 4.x, a new
Analyze Configuration
function key was added to the
Storage Calculator screen.
Pressing this
function key allows the
storage calculator to analyze the
values for your system based on
data received from the switch
and your system configuration.
2-2
The minimum requirements for upgrade from CC
MIS Release 2.x to 5.x are as follows: at least 32
Mbytes RAM, and 460 Mbyte additional disk space
Note:
for the new version of the UNIX Operating System
and CC MIS software, and the SVR4 (NTOS 2.x)
version of UNIX Operating System.

Installing Release 5

There are two types of CC MIS systems for Release 5: Networked and
Stand-alone.
If you are installing CC MIS Release 5 software for the first time, the
order is: perform installation (procedures for upgrades from 3.x to 5.x
and new installations of 5.2 are in this chapter), configure system
(Chapter 6), and establish partitions (Chapter 7). Networked CC MIS
systems need to establish physical nodes and virtual nodes for network
access partitions (NAPs) as described in Chapter 8. Procedures for up-
grades from 4.x to 5.x are presented in Chapter 11.
Preparing for installation
This procedure gathers the information needed to configure the histor-
ical database for each partition (excluding training partitions and net-
work access (NAP) partitions). The table below defines the Data
Storage Worksheet parameters and gives their limits.
These parameters are used solely for computing
disk storage and do not affect the operation within
Note:
CC MIS. The exception is the storage duration
(time and date intervals) parameters which also af-
fect when data is deleted from the disk.
Release 5.2
297-2671-545