Introduction To Release 5; Release 5; Table 2-1: Data Storage Parameters - Nortel CC MIS User Manual

Release 5.2

Section 2: Installing CC MIS

Introduction to Release 5

Data storage parameters
Installing Release 5.0 on a new
system
New OS for
upgrades
from 1.x or 2.x from 1.x or 2.x
CC MIS Maintenance Guide
Release 5
Upgrading from 3.x to 5.0
Preparing Windows-based PCs
for CC MIS
Introduction to Release 5
If you are upgrading from 1.x or 2.x to 3.x then to CC MIS Release 5,
the installation of a new version of the operating system is required.
Upgrades from 3.x or 4.x to 5.1 do not require this OS installation and
can be performed from the Load New Software Version command.
The installation of the new operating system will remove all pre-exist-
ing software and data. Therefore, an upgrade from Release 1.x or 2.x
to Release 3.x will be performed from the UNIX prompt rather than
the "Load New Software Version" command found in the Mainte-
nance Interface. Instructions for installing the new OS are provided in
Appendix C.
Note: ALL user data must be backed up before the operating system
upgrade and then restored.
The initial installation of CC MIS Release 5.2 should
be performed by installation engineers. CC MIS re-
leases older than Release 3.1 cannot be converted to
Release 5 until they have been converted to at least
Release 3.1.
Upgrades from Release 3.1 (or later) to 5.x can be
performed using the options in the System Upgrade
CAUTION
Utility menu - see Chapter 11.
CC MIS
CC MIS
2
2-1