Nortel CC MIS User Manual page 325

Release 5.2
Installing SVR4 OS - continued
11. Press the <Return> key at the prompt. This selects the default (i - install the operating system) and
the installation will continue.
The system scans for, and displays, a list of installed hard disks (as shown in the example message
below). The system then pauses until the <Return> key is pressed.
Proceeding with operating system installation . . .
***> Scanning system for installed hard drives . . .
INSTALL has determined that this system has both a CARTRIDGE
and a DAT tape drive. You must select the tape drive which contains the O/S
installation tape as follows:
c - Selects the CARTRIDGE tape
d - Selects the DAT tape drive
---> Which tape drive contains the O/S tape?
Note: This prompt concerning tape drives only appears if there is both a CARTRIDGE and DAT tape
drive in the system. If there is only one tape device, the prompt will not be displayed (no selection
entry is required for step 11) and the messages in step 12 are displayed.
12. Type c to select CARTRIDGE device or type d to select DAT drive.
13. Regardless of the entry in step 11, the install program continues with the following messages:
INSTALL has identified the following disks in this system:
Disk
----
m187_c0d0 1005MB
m187_c0d1 1005MB
Press RETURN to continue
Note: Disks and disk sizes vary depending on system hardware configuration.
14. Press the <Return> key. The installation then displays the options available (opsys, data, and skip)
for processing the installed disks.
15. After displaying the available options, the installation prompts for the operation to be performed on
each installed disk.
Disk m187_c0d0: 1005MB, SEAGATE ST11200N
-----------------------------------------
---> Enter setup option for disk m187_c0d0 [opsys]:
CC MIS Maintenance Guide
Size Formatted Description
---- --------- ---------
yes SEAGATE ST11200N
yes SEAGATE ST11200N
CC MIS
CC MIS
Installing the operating system
Continued on next page ...
C-3