Nortel CC MIS User Manual page 242

CC MIS
CC MIS
System Log Messages
i_lob, d_lob,
w_lob, m_lob
i_acddn, d_acddn,
w_acddn,
m_acddn
i_walk, d_walk,
w_walk, m_walk
Additionally, the hours of operation parameters may require adjustment.
D Potential hardware or operating system failure. Contact hardware vendor with system error message and
port name.
E Contact design support prior to re-boot of system. Supply complete log messages.
F Possible connectivity problem to switch. Verify all connections and communication equipment between CC
MIS and switch. Verify X.25 port on VME. Contact vendor for X.25 problems.
G Re-enable link in maintenance interface via "Diagnostics/X.25 diagnostics."
H Verify switch datafill parameters. If packet switch used, verify end-to-end X.25 parameters.
I Check/verify switch datafill and status of MPC/EMPC.
J No action required; normal operation of system. If problems are evident, check for other log messages.
K Check/verify MIS session status on switch.
L Potential problem only. Check other log messages carefully. If this log message occurs frequently, contact
design support and supply all log messages.
M Verify consistency of NOS logon parameters and switch datafill.
N Verify that all CC MIS partitions are configured with a valid subpool name.
O Verify that switch datafill parameters do not exceed CC MIS limits.
P Verify switch datafill parameters do not exceed database storage calculator parameters.
Q Verify switch datafill. Contact switch support.
R May be caused by excessive switch or MIS activity. Monitor for other log messages.
S Check/verify switch hardware components (IOC, MPC/EMPC).
T Potential synchronization problem between switch and MIS. If switch datafill has been altered since last
MIS re-initialization, then re-initialize MIS using the "Update Switch Configuration Data" command from
the "Run State Utilities" maintenance menu.
B-2
if table is:
number of ACD groups
average LOBs/group
number of ACD groups
number of Supplementary DNs
DN reassigns per day
number of ACD groups
average walk codes/group
adjust parameters for:
Release 5.2
297-2671-545