Maint Messages - Nortel CC MIS User Manual

Release 5.2

MAINT Messages

Introduction
This section contains error messages generated by the Maintenance process of the CC MIS product. The Maintenance
process writes the messages to their 'Standard Error' device The error messages may contain [XX] and/or 'YYYY'
which denote any numeric and/or string, respectively.
This section lists only those messages which are unique to the Maintenance Process. Messages listed in STANDARD
ERROR MESSAGES on page 1 may also be generated by this process.
Warning Messages
This section lists the warning messages that may be generated by Maint. These messages usually indicate an unusual
condition that can be appropriately handled by the process, and which does not prevent the process from continuing
execution.
Bad return code from cfg_db_next_link_def: xxxx
A link is tagged as having trace file, yet it cannot be found. (Action Code: B)
Partition outside range 0..xxxx
A partition was detected that exceeds the number of current partitions. (Action Code: B)
Error closing index file.
Maint was unable to close the log index file. (Action Code: B)
Error removing index file.
Maint was unable to remove and initialize the log index file. (Action Code:)
Unknown logger command: xxxx (data xxxx)
An unknown command was sent to Maint's log controller. (Action Code:)
Write to system log file returned an error xxxx times yesterday
The Maint process writes to the system log yesterday, returned errors xxxx times. (Action Code:)
Wrote to system log file xxxx times yesterday without a lock.
The Maint process wrote to the system log file xxxx times yesterday without obtaining a lock. (Action Code:)
Fragmented log record - file: yyyy
The log file size is not a multiple of the error message size, the file is damaged. (Action Code:)
Error reading next record offset - file: yyyy
There was an error reading the next record in the log file. (Action Code:)
Error reading current day offset - file: yyyy
CC MIS Maintenance Guide
CC MIS
CC MIS
System Log Messages
B-75