PAIRING SENSORS WITH YOUR WATCH
Pair a heart rate sensor with your watch
When you're wearing a Polar heart rate sensor that's paired with your watch, the watch does not measure
heart rate from the wrist.
1. Wear the moistened heart rate sensor.
2. On your watch, go to
3. Touch your heart rate sensor with your watch and wait for it to be found.
4. Once the heart rate sensor is found, the device ID, for example,
start pairing.
5.
Pairing completed
Pair a stride sensor with your watch
1. On your watch, go to
2. The watch starts searching for your sensor. Touch your sensor with the watch and wait for it to be found.
3. Once the sensor is found, the device ID is displayed. Press OK to start pairing.
4.
Pairing completed
Calibrate stride sensor
There are two ways to manually calibrate your stride sensor via the quick menu. Choose one of the running sport
profiles and then choose
Calibrate by
running: Start the training session and run a distance you know. The distance has to be more than
l
400 meters. When you have ran the distance, press OK to take a lap. Set the actual distance you have ran and
press OK. The calibration factor is updated.
Please note that interval timer cannot used during the calibration. If you have set the interval timer
on, the watch will ask you to turn it off to enable manual stride sensor calibration. You can turn the
timer on from the pause mode quick menu after calibration.
Calibration
factor: Set the calibration factor manually if you know the factor which gives you accurate distance.
l
For detailed instructions on manual and automatic calibration of a stride sensor, see
with Grit X/Vantage V/Vantage
General Settings > Pair and sync > Pair sensor or other device
is displayed when you are done.
General Settings > Pair and sync > Pair sensor or other device
is displayed when you are done.
Calibrate stride sensor
>
M.
Polar H10 xxxxxxxx
Calibrate by running
or
Calibration
145
and press OK.
is displayed. Press OK to
and press OK.
factor.
Calibrating a Polar stride sensor