Vlan Protocol Group Add Protocol; Vlan Protocol Group Remove; Protocol Group - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

6.1.16 vlan protocol group add protocol

This command adds the
. A group may have more than one protocol associated with it. Each interface
<groupid>
and protocol combination can only be associated with one group. If adding a protocol to a
group causes any conflicts with interfaces currently associated with the group, this
command will fail and the protocol will not be added to the group. The possible values for
protocol are
ip, arp,
Default
Format
Mode
6.1.16.1 no vlan protocol group add protocol
This command removes the <
identified by this <
Format
Mode

6.1.17 vlan protocol group remove

This command removes the protocol-based VLAN group that is identified by this
.
<groupid>
Format
Mode

6.1.18 protocol group

This command attaches a
A group may only be associated with one VLAN at a time, however the VLAN
association can be changed.
The referenced VLAN should be created prior to the creation of the protocol-based VLAN
except when GVRP is expected to create the VLAN.
Default
Format
Mode
6-8
to the protocol-based VLAN identified by
<protocol>
and .
ipx
none
vlan protocol group add protocol <groupid> <proto-
col>
Global Config
protocol>
. The possible values for protocol are
groupid>
no vlan protocol group add protocol <groupid>
<protocol>
Global Config
vlan protocol group remove <groupid>
Global Config
to the protocol-based VLAN identified by
<vlanid>
none
protocol group <groupid> <vlanid>
VLAN Config
v4.1, October 2008
from this protocol-based VLAN group that is
and .
ip, arp, ipx
.
<groupid>
VLAN Commands