Table of Contents
Advertisement
v User Security
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
348
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the IMM2 system-event log. Also, after you
complete a repair or correct an error, clear the IMM2 system-event log to turn off
the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
– System Event Log
Select this choice to view the IMM2 system event log.
– Clear System Event Log
Select this choice to clear the IMM2 system event log.
Select this choice to set, change, or clear passwords. See "Passwords" on page
349 for more information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. For more
information, see "Power-on password" on page 349 for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. For more information, see
"Power-on password" on page 349 for more information.
– Set Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is set,
the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see "Administrator
password" on page 350.
– Clear Administrator Password
Select this choice to clear an administrator password. For more information,
see "Administrator password" on page 350.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.
Advertisement
Table of Contents
