Table of Contents
Advertisement
10. Reconnect the power cords and any cables that you removed.
11. Install the system-board tray cover (see "Installing the system-board tray cover"
12. Install the system-board tray in the chassis (see "Installing the system-board
13. Turn on the peripheral devices and the server.
Removing a power supply from a 2U chassis
When you remove or install a power supply from/to a 2U chassis, observe the
following precautions.
Statement 5:
3. If the system-board tray is installed in a chassis, remove it (see "Removing the
system-board tray from a 2U chassis" on page 279).
4. Remove the system-board tray cover (see "Removing the system-board tray
cover" on page 280).
5. Open the retaining clip on each end of the DIMM connector.
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
Alignment
slot
DIMM
6. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the outside of the server. Then, remove the DIMM from the
package.
7. Turn the DIMM so that the alignment slot align correctly with the alignment tab.
8. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector.
9. Firmly press the DIMM straight down into the connector by applying pressure
on both ends of the DIMM simultaneously. The retaining clips snap into the
locked position when the DIMM is firmly seated in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM
has not been correctly inserted; open the retaining clips, remove the DIMM,
and then reinsert it.
on page 280).
tray in a 2U chassis" on page 279).
Alignment tab
Chapter 5. Removing and replacing server components
Retaining
clip
315
Advertisement
Table of Contents
