Table of Contents
Advertisement
2. When you replace the system-board tray, you must either update the server with
3. When you replace the system-board tray, make sure that you remove the
4. See "System-board internal connectors" on page 12 for the locations of the
5. When you replace the system-board tray, make sure that you keep the
To remove the system-board tray, complete the following steps.
3.5-inch
simple-swap
hard disk drive
3.5-inch
filler panel
336
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
ToolsCenter or IBM Systems Director, see the IBM Features on Demand User's
Guide athttp://www.ibm.com/systems/x/fod/ under the Help section.
the latest firmware or restore the pre-existing firmware that the customer
provides on a diskette or CD image. Make sure that you have the latest
firmware or a copy of the pre-existing firmware before you proceed.
Integrated Management Module Advanced Upgrade and place it on the new
system-board tray. For information about the Advanced Upgrade, see "Using the
remote presence capability and blue-screen capture" on page 353.
connectors on the system-board tray.
information of machine type (M/T), serial number (S/N), and product ID from
node serial number label (see "Problem determination tips" on page 258), and
write them down to the repair ID tag accompanied with the FRU of the
system-board. Then, paste the tag onto the bottom side of the new
system-board tray.
3.5-inch
simple-swap
backplate
2.5-inch
simple-swap
backplate
1.8-inch
simple-swap
backplate
1.8 & 2.5-inch
filler panel
2.5-inch
simple-swap
hard disk drive
DIMM
Microprocessor
Power-supply
paddle card
1.8-inch
simple-swap
drive cage
1.8-inch
simple-swap
hard disk drive
System-board tray cover
Heat sink
PCI riser
assambly
System-board tray
Dual-port
Dual-port
network adapter
network adapter
(Optional)
filler
2.5-inch
simple-swap
drive cage
Advertisement
Table of Contents
