Table of Contents
Advertisement
Clearing the error logs
To clear the error logs, complete the following steps.
Note: The POST error log is automatically cleared each time the server is
restarted.
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
3. Use one of the following procedures:
POST
When you turn on the server, it performs a series of tests to check the operation of
the server components and some optional devices in the server. This series of tests
is called the power-on self-test, or POST.
If a power-on password is set, you must type the password and press Enter, when
you are prompted, for POST to run.
18
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Table 3. Methods for viewing event logs (continued)
Condition
The server is hung.
power-on password and an administrator password, you must type the
administrator password to view the error logs.
v To clear the IMM2 system-event log, select System Event Logs --> System
Event Log. Select Clear System Event Log; then, press Enter twice.
Action
v If DSA Preboot is installed, restart the
server and press F2 to start DSA Preboot
and view the event logs.
v If DSA Preboot is not installed, insert the
DSA Preboot CD and restart the server to
start DSA Preboot and view the event
logs.
v Alternatively, you can restart the server
and press F1 to start the Setup utility and
view the POST event log or system-event
log. For more information, see "Viewing
event logs from the Setup utility" on page
16.
Advertisement
Table of Contents
