IBM System x iDataPlex dx360 M4 7912 Service Manual page 318

Problem determination
Table of Contents

Advertisement

1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make a note of where the drives that you plan to remove are installed; then,
3. If the system-board tray is installed in a chassis, remove it (see "Removing the
4. Remove the system-board tray cover (see "Removing the system-board tray
5. Press inward release latch on the hard disk drive bracket and cable assembly;
6. Push down on the release lever at the top of the drive bay; then, grasp the
7. If you are instructed to return the simple-swap SAS/SATA drive cage, follow all
Installing a simple-swap SAS/SATA drive cage
To install a simple-swap SAS/SATA drive cage, complete the following steps.
Filler
panel
1. Slide the simple-swap SAS/SATA drive cage into the bay until the release lever
2. Place the hard disk drive bracket and cable assembly on the mounting tabs
3. Install the system-board tray cover (see "Installing the system-board tray cover"
4. Install the system-board tray in the chassis (see "Installing the system-board
5. Install the hard disk drives, if you removed any (see "Installing a simple-swap
6. Install the filler panel to the hard disk drive bay.
300
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
on page 275.
remove them (see "Removing a simple-swap hard disk drive" on page 293).
system-board tray from a 2U chassis" on page 279).
cover" on page 280).
then, lift the assembly off the mounting tabs and out of the system-board tray.
simple-swap SAS/SATA drive cage and pull it from the hard disk drive bay until
the cage is out of the hard disk drive bay.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Hard disk drive
bracket and cable assembly
Simple-swap
drive cage
Simple-swap
hard disk drive
3
4
secures the cage.
inside the tray; then, press down on the hard disk drive bracket and cable
assembly until the release latch clicks into place.
on page 280).
tray in a 2U chassis" on page 279).
hard disk drive" on page 294).
2
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x idataplex dx360 m4 7913

Table of Contents