Table of Contents
Advertisement
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
3. Select System Event Logs and use one of the following procedures:
Viewing event logs without restarting the server
If the server is not hung, methods are available for you to view one or more event
logs without having to restart the server.
If you have installed Dynamic System Analysis (DSA) Portable, you can use it to
view the system-event log (as the IPMI event log), the IMM2 event log (as the ASM
event log), the operating-system event logs, or the merged DSA log. You can also
use DSA Preboot to view these logs, although you must restart the server to use
DSA Preboot.
To install DSA Portable, or DSA Preboot or to download a DSA Preboot CD image,
go to http://www.ibm.com/support/entry/portal/docdisplay?brand=5000008
&lndocid=SERV-DSA.
If IPMItool is installed in the server, you can use it to view the system-event log.
Most recent versions of the Linux operating system come with a current version of
IPMItool.
For an overview of IPMI, go to http://www.ibm.com/developerworks/linux/blueprints/
and click Using Intelligent Platform Management Interface (IPMI) on IBM Linux
platforms.
You can view the IMM2 system event log through the Event Log link in the
integrated management module II (IMM2) web interface. For more information, see
"Logging on to the web interface" on page 353.
The following table describes the methods that you can use to view the event logs,
depending on the condition of the server. The first three conditions generally do not
require that you restart the server.
power-on password and an administrator password, you must type the
administrator password to view the error logs.
v To view the POST error log, select POST Event Viewers.
v To view the IMM2 system-event log, select System Event Log.
Table 3. Methods for viewing event logs
Condition
The server is not hung and is connected to a
network.
The server is not hung and is not connected
to a network.
The server is not hung and the integrated
management module II (IMM2) is connected
to a network.
Action
Use any of the following methods:
v Run DSA Portable to view the event logs
or create an output file that you can send
to a support representative.
v In a web browser, type the IP address of
the IMM2 and go to the Event Log page.
v Use IPMItool to view the system-event log.
Use IPMItool locally to view the system-event
log.
In a web browser, type the IP address for the
IMM2 and go to the Event Log page. For
more information, see"Obtaining the IP
address for the IMM2" on page 352 and
"Logging on to the web interface" on page
353.
Chapter 3. Diagnostics
17
Advertisement
Table of Contents
