IBM System x iDataPlex dx360 M4 7912 Service Manual page 340

6. Loosen the thumbscrew on the front of the chassis.
7. Push the two retention brackets outward.
8. Grasp the network adapter and disengage it from the pin, retention brackets,
9. If you are instructed to return the adapter, follow all packaging instructions, and
Installing the optional dual-port network adapter
You can purchase a dual-port network adapter to add two additional network ports
in the server. To order a dual-port network adapter option, contact your IBM
marketing representative or authorized reseller.
To install the network adapter, complete the following steps:
322
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Thumbscrew
and the connector on the planar; then, tilt and slide the adapter out of the port
openings on the front of the chassis and remove it from the system-board tray.
use any packaging materials for shipping that are supplied to you.
Pin
Thumbscrew
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 275.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. If the system-board tray is installed in a chassis, remove it (see "Removing the
system-board tray from a 2U chassis" on page 279).
Pin
Network
adapter
connector
Network
adapter
connector
Network
adapter
Captive screws
Retention
brackets
Network
adapter
Captive screws
Retention
brackets