Table of Contents
Advertisement
Installing the system-board tray
Notes:
1. When you reassemble the components in the system-board tray, be sure to
2. When you replace the system-board tray, you must either update the server with
3. When you replace the system-board tray, make sure that you keep the
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code
To install a system-board tray, complete the following steps.
338
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
route all cables carefully so that they are not exposed to excessive pressure.
the latest firmware or restore the pre-existing firmware from a diskette or CD
image. Make sure that you have the latest firmware or a copy of the pre-existing
firmware before you proceed. See "Updating the firmware" on page 341,
"Updating the Universal Unique Identifier (UUID)" on page 359, and "Updating
the DMI/SMBIOS data" on page 361 for more information.
information of machine type (M/T), serial number (S/N), and product ID from
node serial number label (see "Problem determination tips" on page 258), and
write them down to the repair ID tag accompanied with the FRU of the
system-board. Then, paste the tag onto the bottom side of the new
system-board tray.
Advertisement
Table of Contents
