Table of Contents
Advertisement
6. If you are instructed to return the DIMM, follow all packaging instructions, and
Installing a memory module
The following notes describe the types of DIMMs that the server supports and other
information that you must consider when you install DIMMs.
v When you install or remove DIMMs, the server configuration information
v The server supports only industry-standard double-data-rate 3 (DDR3), 800,
310
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
Alignment
slot
DIMM
use any packaging materials for shipping that are supplied to you.
changes. When you restart the server, the system displays a message that
indicates that the memory configuration has changed.
1066, or 1333 MHz, PC3-6400, PC3-8500, or PC3-10600 registered or
unbuffered, synchronous dynamic random-access memory (SDRAM) dual inline
memory modules (DIMMs) with error correcting code (ECC). See
http://www.ibm.com/servers/eserver/serverproven/compat/us/ for a list of
supported memory modules for the server.
– The specifications of a DDR3 DIMM are on a label on the DIMM, in the
following format.
ggggg eRxff PC3v-wwwwwm-aa-bb-ccd
where:
ggggg is the total capacity of the DIMM (for example, 256MB, 512MB,
1GB, 2GB, or 4GB)
eR is the number of ranks
1R = single-rank
2R = dual-rank
4R = quad-rank
xff is the device organization (bit width)
x4 = x4 organization (4 DQ lines per SDRAM)
x8 = x8 organization
x16 = x16 organization
v is the SDRAM and support component supply voltage (VDD)
Retaining
clip
Alignment tab
Advertisement
Table of Contents
