Table of Contents
Advertisement
Installing the 2U chassis fan assembly
To install the 2U chassis fan assembly, complete the following steps.
1. Touch the static-protective package that contains the fan assembly to any
2. Orient the fan assembly over the opening in the chassis. Make sure that the
3. Lower the fan assembly into the chassis and press down on the tab above the
4. Install the top cover (see "Installing the 2U chassis fan-assembly top cover" on
5. Install any system-board trays that you removed (see "Installing the
6. Install the chassis in the iDataPlex rack, (see "Installing the 2U chassis in a
Removing the system battery
The following notes describe information that you must consider when replacing the
battery:
v IBM has designed this product with your safety in mind. The lithium battery must
v If you replace the original lithium battery with a heavy-metal battery or a battery
290
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Fan assembly
unpainted metal surface on the outside of the chassis; then, remove the fan
assembly from the package.
power connector on the fan assembly aligns with the connector on the power
supply.
power connector to make sure that it is fully seated.
page 283).
system-board tray in a 2U chassis" on page 279).
rack" on page 285).
be handled correctly to avoid possible danger. If you replace the battery, you
must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
with heavy-metal components, be aware of the following environmental
consideration. Batteries and accumulators that contain heavy metals must not be
Advertisement
Table of Contents
