Configuring Multicast Hqos Correlation Mode Or Passive Mode - Cisco ASR 9000 Series Configuration Manual

HQoS Correlation
Command or Action
Step 4
qos output minimum-bandwidth range
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# qos
output minimum-bandwidth 10
Step 5
exit
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# exit
Step 6 Use the commit or end command.
Configuring Minimum Bandwidth: An example
configure
dynamic-template
type ppp p1
service-policy output pmap
multicast ipv4 qos-correlation
qos output minimum-bandwidth 10
end

Configuring Multicast HQOS Correlation Mode or Passive Mode

Perform this task to configure multicast in HQoS correlation mode or passive mode to enable multicast
replication over PPPoE interfaces.
SUMMARY STEPS
1. configure
2. dynamic-template
3. type ppp dynamic-template name
4. multicast ipv4 <qos-correlation | passive>
5. Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
238
Configuring Subscriber Features
Purpose
Sets the guaranteed minimum bandwidth, in kbps,
for a subscriber. Range is from 1 to 4294967295.
Exits from the current mode.
commit—Saves the configuration changes and
remains within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits
the configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
OL-28375-03