Table of Contents
Advertisement
©Copyright Agilent
Technologies, Inc. 1992, 1996,
2000, 2001, 2008
All Rights Reserved.
Reproduction, adaptation, or
translations without prior
written permission is
prohibited, except as allowed
under the copyright laws.
Printed: October 2008
Printed in USA
Manual part number
10747-90077
Certification
and Warranty
Certification
Agilent Technologies, Inc.
certifies that this product met
its published specification at the
time of shipment from the
factory. Agilent further certifies
that its calibration
measurements are traceable to
national standards
administered by the U. S. NIST,
NRC Canada, Euromet
members (NPL, PTB, BNM,
etc.) or other recognized
standards laboratories.
Warranty
Agilent warrants Agilent
hardware, accessories and
supplies against defects in
materials and workmanship for
a period specified by each
product from date of shipment.
If Agilent receives notice of such
defects during the warranty
period, Agilent will, at its
option, either repair or replace
products which prove to be
defective. Replacement products
may be either new or like-new.
Agilent Technologies, Inc.
Santa Clara Site
5301 Stevens Creek Boulevard
Santa Clara, California 95052-8059
Agilent warrants that
Agilent software will not fail to
execute its programming
instructions, for the period
specified above, due to defects in
material and workmanship
when properly installed and
used.
If Agilent receives notice of such
defects during the warranty
period, Agilent will replace
software media which does not
execute its programming
instructions due to such defects.
For detailed warranty
information, see back matter.
Safety Considerations
General
This product and related
documentation must be
reviewed for familiarization
with this safety markings and
instructions before operation.
This product is a safety Class I
instrument (provided with a
protective earth terminal).
Before Applying Power
Verify that the product is set to
match the available line voltage
and the correct fuse is installed.
Refer to instructions in Chapter
1 of the Manual.
Before Cleaning
Disconnect the product from
operating power before
cleaning.
Safety Earth Ground
An uninterruptible safety earth
ground must be provided from
the mains power source to the
product input wiring terminals
or supplied power cable.
Safety Considerations
(contd)
Warning Symbols That May
Be Used In This Book
Instruction manual symbol; the
product will be marked with
this symbol when it is necessary
for the user to refer to the
instruction manual.
Indicates hazardous voltages.
Indicates earth (ground)
terminal.
or
Indicates terminal is connected
to chassis when such connection
is not apparent.
Indicates Alternating
current.
Indicates Direct current.
Safety Considerations
(contd)
WARNING
BODILY INJURY OR DEATH
MAY RESULT FROM
FAILURE TO HEED A
WARNING. DO NOT
PROCEED BEYOND A
WARNING UNTIL THE
INDICATED CONDITIONS
ARE FULLY UNDERSTOOD
AND MET.
CAUTION
Damage to equipment, or
incorrect measurement data,
may result from failure to
heed a caution. Do not
proceed beyond a CAUTION
until the indicated conditions
are fully understood and met.
These CAUTION labels are
required by the United States
Center for Devices and
Radiological Health. Failure to
follow their instructions may
result in personal injury.
This symbol indicates laser
radiation
.
CAUTION
LASER RADIATION-DO NOT
STARE INTO BEAM
CONTINOUS WAVE 1mW 670nm
CLASS II LASER PRODUCT
For additional safety and
acoustic noise information, see
back matter.
7.CD.L.03.11.97.R1.J.CW1FL
Advertisement
Table of Contents
