Table of Contents
Advertisement
Chapter 10 Way Straightness Measurements
Introduction
This chapter explains how to make way straightness measurements at
multiple points along a machine part such as a milling machine way.
Since most of the procedures for way straightness measurements are
similar to those for flatness measurements, you are referred to Chapter 9
for certain instructions.
Before performing the procedures described in this chapter, you must fully
understand and know how to perform the procedures presented in the
Agilent 5530 Getting Started Guide.
For measurement operating specifications, see the way straightness
measurement specifications in Appendix A. Since you use the angular
interferometer and reflector to make way straightness measurements, see
the angular measurement specifications in Appendix A for optics
specifications.
Figure 9-1 shows the required optics and mounting hardware for way
straightness measurements.
10-2
Measurements Reference Guide
Advertisement
Table of Contents
