Table of Contents
Advertisement
1
Reflector mounted
horizontally
2
Interferometer mounted
where tool mounts
3
Laser head placed parallel to
spindle, behind tailstock
Chapter 8 Parallelism Measurements
Positioning the Laser Head and Target Machine
1
2
Figure 8-6. Positioning of optics for spindle parallelism measurements—
hollow tailstock
You are now ready to assemble, mount, and align the optics. To make a
spindle parallelism measurement, go directly to "Mounting and Aligning
Optics for Spindle Parallelism Measurements" later in this chapter. To
make a coplanar parallelism measurement, continue with the next
section, "Mounting and Aligning Optics for Coplanar Parallelism
Measurements."
8-10
3
Measurements Reference Guide
Advertisement
Table of Contents
