Table of Contents
Advertisement
Chapter 11 Diagonal Measurements
Assembling the Measurement Retroreflector and Ball-Joint
Assembling the Measurement Retroreflector
and Ball-Joint
Use the instructions below for the retroreflector you choose to use for your
diagonal measurement. Refer to Figure 11-9 for these procedures.
Agilent 10767A Linear Retroreflector
1
Remove any knurled-knob screw from the Agilent 10767A retroreflector.
2
Place the adapter plate over the back of the retroreflector so the
countersunk holes are lined up with the retroreflector holes whose threads
are most easily seen.
3
Use two M3× 0.5× 16 flathead screws to fasten the retroreflector to the
adapter.
4
Screw the adapter plate onto one of the threaded ends of the ball-joint
assembly. Tighten this connection securely, by hand.
5
Set this assembly in a safe place until you install it on the machine.
Agilent 10767B Lightweight Retroreflector
1
Fasten the Agilent 10767B retroreflector on the ball-joint, using an
Agilent 10767-20203 Clamp Nut.
2
Set this assembly in a safe place until you install it on the machine.
Measurements Reference Guide
11-19
Advertisement
Table of Contents
