Table of Contents
Advertisement
6
1
Machine table or surface
plate
2
Base
3
Post
4
Post
5
Right-angle clamp
Chapter 11 Diagonal Measurements
Assembling the Interferometer, Post, Base and Clamp
A similar situation exists at the mirror-axle end of the arm. Again, use
only one setscrew, in the hole that provides easiest access in your
measurement setup. Tighten that setscrew enough to hold the mirror axle
snugly, while still allowing the mirror to rotate.
Set this assembly in a safe place while you assemble other pieces of the
diagonal measurement hardware.
Figure 11-8. Aligning right-angle camp with edge of base
11-18
1
2
3
4
Measurements Reference Guide
5
Advertisement
Table of Contents
