Table of Contents
Advertisement
Chapter 10 Way Straightness Measurements
Aligning the Laser Beam to the Optics' Travel Path
Aligning the Laser Beam to the Optics' Travel
Path
Follow the instructions in "Aligning the Laser Beam to the Machine's
Travel Path for Long-Range Measurements" in Chapter 2. However, note
these exceptions:
•
Use the procedures in Chapter 2 regardless of the length of your
measurement line.
•
Instead of moving the machine's moveable part, move the reflector.
You are now ready to complete the Set Up WAY STRAIGHTNESS screen.
Completing the Set Up Way Straightness
screen
This screen allows you to supply the software with general measurement
setup information, such as the foot spacer length. To complete this screen,
follow these steps:
1
On the Other Measurements screen, select Way Strat.
The Set Up WAY STRAIGHTNESS screen is displayed (Figure 10-3).
10-6
Measurements Reference Guide
Advertisement
Table of Contents
