Peripheral Power Cable; Removing The Peripheral Power Cable - Sun Microsystems Ultra 1 Series Service Manual

Peripheral Power Cable

1. Remove the two screws securing the drive bracket to the chassis.
See Figure 8–17.
Figure 8–17 Removing the Drive Bracket
2. Remove the DC harness from the clip located on the drive bracket.
See Figure 8–17.
3. Disconnect the DC harness from the peripheral power cable at P1.
4. Push the drive bracket toward the disk drive bay, and gently flip it over. Place
it on top of the disk drive bay.
57
Major Subassemblies