Replacing The Nvram/Tod - Sun Microsystems Ultra 60 Service Manual

5. Remove the NVRAM/TOD as follows (
a. Locate the NVRAM/TOD and carrier on the motherboard.
b. Grasp the NVRAM/TOD carrier at each end and pull straight up.
Note – Gently wiggle the NVRAM/TOD as necessary.
6. Place the NVRAM/TOD and carrier on an antistatic mat.
FIGURE 10-2
10.2.2

Replacing the NVRAM/TOD

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
10-6 Sun Ultra 60 Service Manual • August 2001
NVRAM/TOD
Carrier
Removing and Replacing the NVRAM/TOD
):
FIGURE 10-2