Table of Contents
Advertisement
Replacing the 200K Maintenance Kit
The following message appears on the printer's control panel when the 200K Maintenance kit is
near or reaches the end of its service life.
Ready
Trans. Roll
Important
• Do not touch the roller part of the 2nd BTR Unit.
Replacing the 2nd BTR Unit
1.
Switch off the power.
Important
• While the printer is in the Energy Saver mode, press the
<Energy Saver> button to exit the mode, and then switch
off the power.
Refer to
• For information on how to switch off the power and the
main power, refer to "2.2 Switching On/Off the Power"
(P. 46).
2.
Open Tray 5 (1), and then while lifting up the
release lever (2) gently open the upper left
cover A (3).
3.
Push the lever in the direction of an arrow.
4.
Take out the 2nd BTR Unit.
310
7 Maintenance
Message
Replace
Action
The 2nd BTR Unit and Paper Feed Rolls need to be
replaced soon. Use the 200K Maintenance Kit to
replace them.
Advertisement
Table of Contents
