SSL/TLS
[SNMP]
Note
• SNMP must be configured when using an application to remotely manage multiple printers. SNMP manages
printer information and provides it to the management application.
Port Status
TransportProtocol
148
5 Control Panel Settings
Setting
Sets whether to enable or disable SSL encrypted communications.
• [Disabled] (default)
• [Enabled]
Note
• Client certificate is necessary for SSL communications.
Configure an appropriate certificate on the printer.
Network/Port
SNMP
Setting
Sets whether to enable or disable the SNMP port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Sets the protocol of the transport layer used by SNMP. Either or both of IPX and
UDP can be selected.
• [UDP] (default)
• [IPX]
• [IPX, UDP]
Note
• When using UDP protocol, both the printer and client computers must have IP
addresses.
• To determine which protocol (IPX or UDP) to use, refer to the manual supplied for
the application.
Description
SNMP
Port Status
SNMP
TransportProtocol
Description