Table of Contents
Advertisement
Setting
No. of searches
TBCP Filter
[SMB]
Network/Port
SMB
Setting
Port Status
TransportProtocol
Print Mode
Sets the number of times that the file server is searched.
Set from 1 to 100 in "times" units or [No Limit]. Searches are performed at 1-minute
intervals. (See *2 on P. 202.)
• [No Limit] (default)
• [1 Time(s)] to [100 Time(s)]
Sets whether to enable or disable the TBCP filter during processing of PostScript
data.
• [Disabled] (default)
• [Enabled]
SMB
Port Status
SMB
TransportProtocol
SMB
Print Mode
SMB
PJL
SMB
TBCP Filter
Sets whether to enable or disable the SMB port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Sets the protocol of the transport layer used by SMB.
Either or both of NetBEUI and TCP/IP can be selected.
• [TCP/IP,NetBEUI] (default)
• [TCP/IP]
• [NetBEUI]
Note
• When using TCP/IP protocol, both the printer and client computers must have IP
addresses.
Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. (See *1 on P. 202.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
• [HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). (See *3 on P. 202.)
Description
Description
5.2 Common Menus Setting
139
Advertisement
Table of Contents
