Table of Contents
Advertisement
Error Code
024-746
A function (paper size, paper tray, or duplex printing) has been specified that cannot be used in
combination with the specified paper quality.
Check the print data.
024-747
Incompatible print parameters are used. The combination of the specified features such as Document
Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is incompatible.
024-775
The number of prints of a job for which booklet is specified with print options exceeds the number of
booklets that can be printed.
Use print options to divide the job so the number of prints is within the allowable range for booklet or
cancel booklets.
025-596
An error occurred with the hard disk.
025-597
Replace the hard disk.
026-400
More than two devices are connected to the USB host port.
Disconnect the third or more devices so that the number of connected devices becomes two. If the error
still is not resolved, switch off the machine power, make sure that the display is blank, and then switch
on the machine power.
026-704
An error occurred during processing DocuWorks documents.
Open the DocuWorks file with DocuWorks or DocuWorks Viewer. From the [File] menu, select [Print], and
then select the print driver to use for printing.
026-705
Unable to process for DocuWorks documents because of insufficient memory space.
Perform one of the following steps.
In the [Print setting] dialog box of ContentsBridge Utility, change the [Print Mode] setting as follows:
• When [High Quality] is selected, change the value to [Standard], or [Standard] is selected, change the
value to [Fast].
• Install the Extension System Memory (optional) to increase the capacity of memory.
• Open the DocuWorks file with DocuWorks or DocuWorks Viewer. From the [File] menu, select [Print],
and then select the print driver to use for printing.
026-706
Attempted to print a DocuWorks document of which printing is prohibited.
Release the print prohibited settings using DocuWorks Viewer, and then execute the operation again.
Refer to
• DocuWorks manual
026-707
When processing password-protected DocuWorks documents, the password entered does not match
that of the DocuWorks document.
Set the correct password on this printer or ContentsBridge Utility.
Note
• Refer to the " [XDW (DocuWorks)]" (P. 134) to change [XDW(DocuWorks)] setting on the control panel
when directly printing DocuWorks file without ContentsBridge Utility.
026-718
Incompatible print parameters are used. The combination of the specified features such as Document
Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is incompatible.
Confirm the print data, and try printing again.
026-724
The communication with the EP server has been failed.
026-725
Switch off the machine power, make sure that the display is blank, and then switch on the machine
power.
If the error still is not resolved, contact our Customer Support Center.
026-726
The machine configuration information at a print job specification does not match the actual machine
configuration.
Modify the machine configuration information in the print driver screen to match the actual machine
configuration.
026-730
The paper is not loaded correctly.
Check the following:
• The paper guides are correctly positioned in the tray.
• The maximum allowable number of printable pages has been exceeded.
• The tray is extended.
Cause/Remedy
6.7 Error Messages and Error Codes
271
Advertisement
Table of Contents
