Table of Contents
Advertisement
6.
Pull out the handle on the control board and
then carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
7.
Remove the two screws that secure the
Gigabit Ethernet Board Kit.
Note
• The screws you remove here may be used for securing
other optional kit on the control board
8.
Remove the Gigabit Ethernet Board Kit from
the control board.
Gigabit Ethernet Board Kit removal is now complete.
It no other installation for the optional kit is needed, install the dummy plate that you removed
in step 7 in the "Installing the Gigabit Ethernet Board Kit" (P. 405), insert the control board, and
then secure the board with three screws in place.
.
screw
A.8 Installing the Gigabit Ethernet Board Kit
409
Advertisement
Table of Contents
