Table of Contents
Advertisement
5.
Loosen the three screws on the control board
of the printer.
6.
Pull the handle on the control board and then
carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
7.
Remove the three screws on the control board
and then remove the dummy plate.
Note
• Note that you will need the screws you remove here in
step 9 of this procedure.
8.
Aligning the Gigabit Ethernet Board Kit (with
frame) with the control board connectors,
insert the kit from above into the connectors.
9.
Use the screws you removed in step 7 to
secure the Gigabit Ethernet Board Kit to the
front plate of the control board.
406
A Appendix
screw
screw
screw
Advertisement
Table of Contents
