System; Incorporating An Fru Of The Crossbar Box Into The System - Fujitsu M10-4 Service Manual

------------------------------------------------------------------------------
Maintenance/Replacement Menu
Status of the replaced FRU.
FRU Status
------------------- --------------
/BB#0 Normal
------------------------------------------------------------------------------
The replacement of BB#0 has completed normally.[f:finish] : f
5.
When the maintenance menu appears, enter "c" to exit the operation.
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a type of model which has FRU to be replaced.
1. BB (4s Building Block Model)
2. XBBOX (XB-BOX Model)
------------------------------------------------------------------------------
Select [1,2|c:cancel] : c
6.1.2 Incorporating an FRU of the crossbar box into the

system

If the maintenance target is a crossbar box, the following are targeted as FRUs:
Chassis of the crossbar box
■
Power supply unit of the crossbar box
■
Fan unit of the crossbar box
■
XSCF unit of the crossbar box
■
1.
After completing maintenance of the target FRU, return to the replacefru
command operation of the XSCF firmware, and enter "f".
Please execute the following steps:
1) Confirm the XSCF STANDBY LED of XBBOX#81/XSCFU is not lit.
2) Remove XBBOX#81/XSCFU.
3) After installing the exchanged device, please select [f:finish] : f
The following screen is displayed. Wait until the processing has completed.
Waiting for XBBOX#81/XSCFU to enter install state.
[This operation may take up to 20 minute(s)]
(progress scale reported in seconds)
0..... 30..... 60..... 90..... 120..... 150..... 180..... 210.....
240..... 270..... 300..... 330..... 360..... 390..... done
Chapter 6 Understanding the Preparations for Restoring the System 73