Fujitsu M10-4 Service Manual page 45
Hide thumbs
Also See for M10-4:
- Service manual (514 pages) ,
- Safety and compliance manual (63 pages) ,
- Service manual (342 pages)
Table of Contents
Advertisement
Location number
Component
3
Power switch
Use the BB-ID switch to set the BB-ID number of the SPARC M10-4S or the crossbar
box. Set #0 to #15 for the SPARC M10-4S and #80 to #83 for the crossbar box.
describes how to operate the BB-ID switch.
Table 2-2 How to operate the BB-ID switch
Operation
Pressing the + side.
Pressing the - side
Use the mode switch to set the operation mode for the system. The Locked and
Service operation modes can be switched by sliding the mode switch.
Table 2-3
describes the difference between the modes.
Table 2-3 Functions of the mode switch
Icon
Name
Locked mode
Service mode
Use the power switch to start or stop the system. The system starts/stops differently
depending on how the power switch is pressed.
Table 2-4
describes how system start/stop varies depending on how the power switch
is pressed.
Description
The BB-ID number increases by 1.
The BB-ID number decreases by 1.
Description
This mode is used for normal operation.
- The power switch can be used to start the system but not to
stop it.
This mode is used for maintenance.
- The power switch cannot be used to start the system but can be
used to stop it.
- Place the system in Service mode to perform maintenance
work with the system stopped.
Chapter 2 Understanding the System Components
Table 2-2
21
Advertisement
Table of Contents
