Fujitsu M10-4 Service Manual page 371

Check the guide plate latch to ensure that the plate is securely installed.
4.
Support the fan shelf from below with one hand and then insert it carefully
into the chassis.
Arranging the cables in the center makes it easier to install the fan shelf.
5.
Tighten the three screws securing the fan shelf.
6.
Connect the two cables to the fan shelf.
7.
Install the lower cover and then secure it with the one screw.
8.
Install the upper cover.
9.
Slide the right and left stoppers of the upper cover outwards and then secure
the cover with the two screws.
10. Install all the fan units.
For details, see
11. Install the front cover.
For details, see
12. Reinstall the following components in their original positions in the order
shown.
- Power supply unit
- Crossbar unit or crossbar filler unit
- XSCF interface unit
- XSCF unit
21.6 Restoring the System
This section describes the procedure for restoring the system after installing a
crossbar backplane unit.
1.
Turn on the CB switches of the dedicated power distribution unit (PDU)
mounted on the rack for expanded connection.
Open the rear door of the rack, and push in all the CB switches on the PDU.
Electricity is supplied when the switches stay pushed in.
2.
Execute the diagxbu command to diagnose the crossbar cables.
- When the system board of the chassis connected with the crossbar cables
"19.5 Installing a Fan
"6.5.3 Installing the front
For details, see "18.5 Installing a Power Supply
For details, see "16.5 Installing a Crossbar
For details, see "20.5 Installing the XSCF Interface
For details, see "17.5 Installing the XSCF
is not incorporated into the physical partition, or when the incorporated
physical partition is powered off:
The example below specifies the following:
00: The BB-ID of the chassis to start the diagnosis
01: The BB-ID of the destination where the chassis to start the diagnosis is
Chapter 21 Maintaining the Crossbar Backplane Unit of the Crossbar Box
Unit."
cover."
Unit."
Unit."
Unit."
Unit."
347