Fujitsu M10-4 Service Manual page 380

Figure 22-7 Removing the screws and bracket
8.
Remove the fan backplane.
Note - Place the removed fan backplane on a grounded antistatic ESD mat.
22.5 Installing the Fan Backplane
This section describes the procedure for installing the fan backplane.
22.5.1 Installing the fan backplane
1.
Fit the fan backplane into the right- and left-hand notches in the fan shelf.
2.
Install the bracket of the fan backplane and secure it with two screws.
3.
Connect the two cables to the fan backplane.
4.
Support the fan shelf from below with one hand and then insert it carefully
into the chassis.
Arranging the cables in the center makes it easier to install the fan shelf.
5.
Tighten the three screws securing the fan shelf.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
356
A