Restoring The System - Fujitsu M10-4 Service Manual

Note - Reinstall the cables in the correct positions by referring to the notes you made before
starting maintenance.
5.
Lift the cable support to fix it.
For details, see
If you are not using equipment rack model 26xx or equipment rack model 16xx,
the procedure ends here. You do not have to perform step 6.
6.
Connect the crossbar cables to the cable support.
Perform this procedure only when equipment rack model 26xx or equipment
rack model 16xx is used. The procedure may vary depending on the model of
the equipment rack.
Procedure when equipment rack model 26xx is used
a. Remove the hook-and-loop fastener of the crossbar cables from the cable
b. Remove the screw securing the cable holder, and then rotate the cable
c. Connect all the crossbar cables to the crossbar unit.
d. Use the hook-and-loop fastener to fix the crossbar cables to the cable
Note - Connect the crossbar cables in their original positions by referring to the notes that
you made before the start of maintenance.
Procedure when equipment rack model 16xx is used
a. Remove the crossbar cables from the hook-and-loop fastener installed on
b. Connect all the crossbar cables to the crossbar unit.
c. Use the hook-and-loop fastener to fix the crossbar cables to the cable
Note - Connect the crossbar cables in their original positions by referring to the notes that
you made before the start of maintenance.
7.8

Restoring the System

This section describes the procedure for restoring the system after a CPU memory
unit is replaced, expanded, or reduced. The restoration procedure differs depending
on the maintenance type as follows:
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
158
"6.5.2 Fixing the cable
holder.
holder through 180 degrees to install it on the supporting column at the
rear of the rack.
support.
the supporting column on the rear of the rack.
support.
support."