Fujitsu M10-4 Service Manual page 187

To specify multiple connection destination BB-IDs, enter a command like
"diagxbu -y -b 00 -t 01 -t 02".
XSCF> diagxbu -y -b 00 -t 01
4.
Execute the restoreconfig command to restore the XSCF setting information
only when the CPU memory unit lower in a singe-chassis configuration has
been replaced.
If the CPU memory unit lower has not been replaced or if the microSD card has
been switched, restoration is not necessary. Proceed to step 5.
a. Log in to the XSCF shell.
Note - If you cannot log in with an XSCF user account and password, use the default user
account of the XSCF to log in to the XSCF. For details, see "6.3 XSCFにログインする" in the
Fujitsu M10/SPARC M10 Systems Installation Guide.
b. Execute the restoreconfig command to restore the XSCF setting
information that has been saved with the dumpconfig command.
For details, see "10.9.3 XSCF設定情報を復元する" in the Fujitsu M10/SPARC
M10 Systems System Operation and Administration Guide.
XSCF> restoreconfig
c. Execute the version command to confirm the firmware version information.
If the XCP firmware version does not match that used before the replacement,
update the firmware.
For details, see "16.1.3 Updating firmware" in the Fujitsu M10/SPARC M10
Systems System Operation and Administration Guide.
If you replaced the microSD card, the CMU firmware versions do not match.
However, you do not need to perform an update.
The following example shows "02.01.0001" (*1 in the execution example) as the
CMU firmware version of the current XCP, and "02.00.0006" (*2 in the
execution example) as the CMU firmware version of the reserve XCP. Thus,
you can see that the CMU firmware versions do not match.
XSCF> version -c xcp -v
BB#00-XSCF#0 (Master)
XCP0 (Current): 2011
CMU : 02.01.0001 (*1)
POST : 1.20.0
OpenBoot PROM : 4.34.0+1.2.0
Hypervisor : 0.21.11
XSCF : 02.01.0001
XCP1 (Reserve): 2011
CMU : 02.00.0006 (*2)
POST : 1.13.0
OpenBoot PROM : 4.34.0+1.0.5
Chapter 7 Maintaining the CPU Memory Units 163