Fujitsu M10-4 Service Manual page 159

by adjusting the position of the board so that the outer circumference of the
threaded hole of the frame can be seen (E in the figure).
c. Attach the connector by pressing down the connector units (F and G in the
figure) located at the center of the right and left sides of the board at the
same time.
Figure 7-49 Installing the CPU memory unit board (for the SPARC M10-4/M10-4S
with a FRAME-A CPU memory unit)
F
- For the SPARC M10-4S with a FRAME-B CPU memory unit
Install the CPU memory unit board with the left and right guides (A and B in
the figure) and the left guide on the board (C in the figure) as a guide.
a. Insert the board carefully into the frame, keeping it horizontal.
b. Attach the connector by pressing down the connector units (D and E in the
A
D
Chapter 7 Maintaining the CPU Memory Units
G
E
C
B
135