Fujitsu M10-4 Service Manual page 278

# ldm stop iodomain
# ldm remove-io /BB1/PCI0 iodomain
e. Release from the physical partition the chassis in which the PCIe card
13.4.3 Inactive/Hot maintenance
Note - Inactive/hot maintenance can be performed only for a building block configuration.
For a single-chassis configuration, system-stopped maintenance should be performed.
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see
3.
Power off the physical partition requiring maintenance.
For details, see
13.4.4 System-stopped maintenance
The PCIe cards can be removed/installed while the input power to the chassis is on
(power cord is connected).
This section explains how to perform all types of maintenance work while the power
cord of the chassis remains connected.
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see
3.
Stop the entire system.
For details, see
13.5 Removing a PCI Express Card
This section describes the procedure for removing a PCIe card. Perform reduction
using the same procedure.
For installation, remove the filler for a PCIe card instead of removing a PCIe card.
Enable the removal of the PCIe card before attempting to remove it. For details, see
"13.4 Enabling the Removal of a PCI Express
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ February 2014
254
requiring maintenance is mounted.
For details, see "5.2 Releasing a Chassis from the Physical
"4.2 Confirming the System
"5.3 Powering Off the Physical Partition Requiring
"4.2 Confirming the System
"5.4 Stopping the Entire
Partition."
Configuration."
Configuration."
System."
Card."
Maintenance."